eFoil stand, hardware kits & service parts
The eFoil stand plus the replacement hardware, seals, and service parts that wear over time.
In this article
eFoil Stand
A purpose-built platform that holds your board so you can attach/detach propulsion, swap wings, charge the battery in-board, dry the system, and store it safely. Hand-crafted wooden stand, lightweight, fits all Lift eFoil boards (LIFT3 through LIFTX) and all wing configurations. A next-gen stand is also available. Without a stand, servicing means flipping the board on the ground — risking the deck pad, carbon wings, and propulsion.
Hardware kits
eFoil Hardware Kit (LIFT3 / LIFT4) — mast screws, wing screws, ReelX sealant, hatch tape, reusable mesh bag.
LIFT5/LIFTX Hardware Kit — LCS mast seal kit + battery pin seal kit.
eFoil Mast Hardware Kit / eFoil Wing Hardware Kit — replacement screws for the mast and wing connections.
Adapters
AC Adapter — regional power plug for your charger (US, Euro, UK/HK, Australia, Italy, Japan, South Africa).
Adapter Data Cable — Fischer (5-pin) to ODU (8-pin) — bridges different-generation eBox and battery connectors.
Service parts & spares
The small items that wear out, get lost, or need replacing:
Deck: eFoil Deck Pad (4'2"–6'2" sizes)
Battery hatch: Carbon Fiber Latch (set of 2), Latch v2, Friction Hinge (set of 2), Cam-Lock Repair Kit
Wireless: Antenna, Antenna Hook v2
Electrical/motor: Replacement Power Button (with cables), Tri Color Phase Seals (set of 6 — see Phase seal maintenance)
Cooling system: Female/Male Water Connectors
LCS: Base Plate, Shroud Assembly, Ripcord LCS Assembly, Mast Sub-Assembly (Absorber), 3" Fuselage Extender
Carry handles: eFoil Handles (LIFT3 / LIFT3 F)
Misc: Custom Dowel Nut (mast fastener)
Rinsing with fresh water and applying ReelX to electrical contacts after every session is the single best way to extend the life of these parts. See Maintenance guide.